Windows 2008 dns replication

Scroll to the Summary table near the bottom of the file. Note the names of all the domain controllers that report "Warn" or "Fail" status in the Summary table. Try to determine if there is a problem domain controller by finding the detailed breakout section by searching for the string "DC: DCName," where DCName is the actual name of the domain controller.

If you see obvious configuration changes that are required, make them, as appropriate. For example, if you notice that one of your domain controllers has an obviously incorrect IP address, you can correct it.

Then, rerun the test. If you do not have IP version 6 IPv6 enabled on the domain controller, you should expect the host AAAA validation portion of the test to fail, but if you are not using IPv6 on your network, these records are not necessary.

You can use the following procedure to verify resource record registration, including alias CNAME resource record registration. If the alias CNAME resource record is not registered, verify that dynamic update is functioning properly.

Sign up using Facebook. Sign up using Email and Password. Post as a guest Name. Email Required, but never shown. The Overflow Blog. Stack Gives Back Safety in numbers: crowdsourcing data on nefarious IP addresses. Featured on Meta.

New post summary designs on greatest hits now, everywhere else eventually. Related 1. Hot Network Questions. Question feed. Server Fault works best with JavaScript enabled. The contoso. This change is replicated to DC2 , and then the contoso. In this scenario, the zone transfer settings on DC2 are removed.

The following changes occur:. The list of servers to which zone transfer was previously allowed is removed. The server values are also removed from the registry. This issue occurs because the existing zone object is deleted from the partition, and a new object is created in the corresponding partition when the replication scope is changed. This change is replicated across all domain controllers. When the polling thread on DC2 pulls the change from the new partition, the registry settings for are reset.

Zone transfer is disabled because the value of SecureSecondaries is set to 3. Also, any configured servers in the zone transfer list are removed because the SecondaryServers value is removed.

This text file can be shared with other DNS servers that store their information in a text file. Finally, a Standard Secondary zone simply creates a copy of the existing database from another DNS server.

This is primarily used for load balancing. Step 3: Click on the Yes,create the forward lookup zone now on the forward lookup zone window. Step 4: Click on the desired zone that you want to create, in this case Primary Zone. After the installation and configuration of the forward and reverse lookup zone, now the server is ready to create the other records associated with the DNS and Zones. There are several records available, here i am listing some of the important records.

Specifies authoritative information about a DNS zone, including the primary name server, the email of the domain administrator, the domain serial number, and several timers relating to refreshing the zone.

The following properties window shows the information about the SOA record of the Geeksite. Name Servers that specify name servers for a particular domain.