NOTE 1: Never add the ground coffee when the machine is off, to prevent it from spilling inside the machine. NOTE 3: When dosing the quantity of coffee to be added, only use the measure supplied.
NOTE 5: If you add more than one measure of pre-ground coffee and the funnel blocks, use a knife to push the coffee down Fig.
Once the coffee has been delivered, to make coffee using the beans again, deactivate the ground coffee function by pressing the button again the light goes off and the coffee grinder is enabled for operation again.
Turn the milk frother towards the outside of the machine Fig. Position a container underneath the milk frother Fig. Turn the steam knob half a turn in anticlockwise until it stops Fig. It is recommended to deliver hot water for no more than 2 minutes. When choosing the size of the container, remember that the volume will increase by 2 or 3 times. It is recommended to use partially skimmed milk at fridge temperature. The light Fig. Be careful, to avoid being scalded.
The steam released will make the milk froth and increase in volume. To make creamier foam, dip the milk frother into the milk and rotate the container with slow movements from the bottom to the top you are recommended to limit steam delivery to no more than two minutes at a time. The cappuccino is now ready add sugar to taste and if desired, sprinkle the foam with a little cocoa powder. NOTE 1: : immediately after having prepared the cappuccino, once having pressed the steam button Fig.
HINT: To cool it down more quickly, after having deactivated the steam function, open the steam knob and release some water from the milk frother into a container, until the green and lights stop flashing. NOTE 2: The milk frother must always be cleaned after use. GB Fig. Turn the knob clockwise as far as it will go. With one hand, hold the cappuccino tube firm and with the other unscrew the cappuccino maker itself by rotating clockwise and extracting downwards fig.
Remove the steam nozzle from the delivery spout by pulling it downwards Fig. Carefully wash the milk frother and the steam nozzle in warm water.
Check that the two holes indicated by the arrows in Fig. If necessary, clean them using a needle or pin. Replace the steam nozzle by inserting it and vigorously turning it upwards into the steam spout.
Replace the milk frother by pushing it upwards and turning it anticlockwise. A soft damp cloth will suffice. When the indicator starts to become visible a few millimetres under the drip tray , the drip tray must be emptied and cleaned. To clean them, scrape the dry coffee residues with a needle Fig. Steam nozzle Milk frother Fig. To remove the coffee stuck to the parts inside the machine, scrape it with a plastic or wooden fork Fig. Support Pin Bottom pipe on the infuser. The pin must be inserted into the bottom pipe on the infuser.
NOTE 2: if it is hard to insert the infuser, before inserting it squeeze it into size by pressing it vigorously from above and below at the same time, as shown in Figure 32 NOTE 3: if it is still hard to insert the infuser, leave it out of the machine, close the service door, unplug from the mains then plug in again.
Wait for all the lights to go off, then open the door and replace the infuser. When the light starts flashing chap. NOTE: when the light switches on, the coffee maker can still be used to prepare coffee. The light inside the button switches on chap. The descaling solution will come out of the milk frother and start to fill the container underneath.
Hot water will come out of the milk frother and fill the container underneath. NOTE: if the descaling procedure is stopped before completion, the alarm chap.
If necessary, this period of operation can be extended, thus making the descaling operation less frequent, by programming the machine based on the actual lime content in the water used. The four lights , , and come on. The coffee maker is now programmed to provide the descaling warning when effectively necessary, based on the actual hardness of the water..
Wait for the indicator lights to come on steady before making the coffee. Wait for the light to come on steady before turning the steam knob. The tank is dirty or lined with lime Rinse or descale the tank. The coffee comes out too slowly. Turn the grinding adjustment knob Fig. The grounds container has not Open the access door and replace the grounds container. The light flashes 4 The ground coffee has not been Add the ground coffee as described in par.
Fill the container with beans, as descriNo more coffee beans bed in par. The machine makes a strange noise and the four lights , , and flash alternately. After cleaning, the infuser has pro- Leave the service door closed and the bably been left out of the coffee infuser out of the coffee maker. Only when all four lights are off can the door be opened and the infuser inserted to insert the infuser see par.
The , and lights are on and flashing The machine has been switched on Turn the steam knob clockwise all the with the steam knob in the open way round Fig. The 9 light light is flashing The service door is open. Press the infuser where marked PUSH until hearing the click. Check that the two red buttons open out correctly par. Close the service door and press the button.
If the service door cannot be closed, check that the infuser is inserted correctly par. The ground coffee funnel is clog- Empty the funnel with the help of a knife, as described in par. If, on the other hand, no alarm light is on, run the following checks before calling the service centre. Heat the cups by rinsing them in hot water or leaving them to rest for at least 15 minutes on the cup warmer tray on the lid see par.
Turn the right-hand knob Fig. Search Frequently Asked Questions. S here simply to other product owners. Provide a clear and comprehensive description of the problem and your question. S owners to provide you with a good answer. In the class of the most affordable bean-to-cup coffee machines, a fight to the death has been raging for quite some time.
Their price policies differ depending on the market: Delonghi offers a better price in some countries for example, ESAM SB in the UK , sometimes Saeco engages in price dumping in case of Xsmall in US and in other places they are neck and neck, for instance on the German market.
In fact, the ESAM B and ESAM Therefore, everything covered by this review concerns any Delonghi ESAM machine with the model numbers , , , , , or — they are all the same in terms of functionality. The letter at the end of the name, e.
B or SB, can be easily ignored, as it only denotes the colour. It has a classic pump with a maximum pressure of 15 bar and a W thermoblock. The design is smart and easy to use. The containers for coffee beans grams , water 1. It may be not enough for an office unless there are only two people working there , but is just fine for home use. It is very easy to maintain — I recommend rinsing it under a strong stream of tap water every week.
Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other DeLonghi Magnifica ESAM owners to properly answer your question. This manual comes under the category Coffee makers and has been rated by 51 people with an average of a 8. This manual is available in the following languages: English. Is your question not listed?
V Pestalozzi Col. Narvarte Del. Benito Juarez C. Index A
0コメント